Fishman F1 Analog Acoustic System User Guide



Yüklə 159,79 Kb.
Pdf görüntüsü
tarix02.10.2018
ölçüsü159,79 Kb.
#71912


www.fishman.com

USER GUIDE

F1 ANALOG™


Welcome

Thank you for making Fishman a part of your acoustic experience. We are proud 

to offer you the fi nest acoustic amplifi cation products available; high-quality

professional-grade tools to empower you to sound your very best. We are

confi dent F1 Analog will both enhance and inspire your music making.



3

Quick Start

Before you begin, set the controls as shown:



1. Plug in • Use a ¼-inch instrument cable.

2. Tune up • Press and hold the 

Volume knob until 

the tuner comes on. When engaged, the Tuner mutes 

the output. Press 

Volume to exit Tuner.

3. Turn up • Raise the 

Volume to a desirable level.



4. Adjust Tone • Turn the 

Tone knob clockwise to 

blend in a “mid-scooped” tone with emphasized bass 

& treble and reduced midrange.

Tone

Volume



4

Controls

Volume

For the cleanest noise-free sound, turn the 

Volume knob as high as possible 

without causing your amp or mixer to distort.



Tone

This innovative one-knob tone control lets you choose between a natural

undersaddle sound with no EQ (fully counter-clockwise) on up to a “mid-

scooped” tone with emphasized treble & bass and reduced midrange.

•  To make individual notes sound thicker and punchier, turn the 

Tone 


control clockwise.

• Try the 

Tone control in the middle position for fi ngerpicking, when you 

need just a bit of midrange cut.

Turn the 

Tone control counter-clockwise for more depth and clarity to 

your sound, especially for hard strumming.



5

Controls (cont.)

Phase

Use the 


Phase control to improve bass response at low volume and suppress 

feedback at high volume. To adjust, press and release the Tone knob 

several times and leave it in the position most pleasing to your ear.

Tuner

Press+hold Volume 2 seconds to turn tuner on.

Press Volume once to turn it off.

This digital chromatic tuner accommodates all 

tunings and mutes the output when engaged.

It can be activated without an instrument cable 

connected, in which case it will turn itself off 

after 30 seconds of inactivity.

The tuner is calibrated to A = 440.

“A” note


below pitch

“A” note


above pitch

“A#” note

in tune

note raised



1/2 step


6

Power

Plug in the guitar, and F1 Analog switches on. To conserve the battery, remove 

the instrument cable from the guitar when the system is not in use.

Low Battery Indicator

A low battery LED is built into the preamp housing mounted inside the guitar. 

When the Battery LED lights steadily, it is time to change the battery. You can 

expect approximately 185 hours of continuous use between battery changes.




7

Electrical Specifi cations

Typical in-use current consumption @ 9VDC: 

2.7mA

Typical 9V lithium battery life: 



370 hours

Typical 9V alkaline battery life: 

185 hours

Nominal output impedance: 

1k Ohm

Recommended load impedance: 



10k Ohm and up

Maximum output level (onset of clipping): 

+6.5dBV

Baseline noise: 



-96dBV

Dynamic Range:  

102dB

All specifi cations subject to change without notice.




www.fi shman.com

513-300-173 Rev B 9-10



Yüklə 159,79 Kb.

Dostları ilə paylaş:




Verilənlər bazası müəlliflik hüququ ilə müdafiə olunur ©genderi.org 2024
rəhbərliyinə müraciət

    Ana səhifə