8.13DV D1
Modification: Add the following paragraphs:
Additional tests are required for adhesive labels to test the durability of the adhesive
system.
Compliance is checked by inspection and, if the label is not in compliance with C22.2 No.
0.15 and UL 969, the following tests.
After being subjected to the conditions described below, a pressure sensitive label or a
label secured by cement or adhesive shall be considered to be of a permanent nature if (1)
immediately following removal from each test medium and (2) after being exposed to room
temperature for 24 hours following removal from each medium:
a) Each sample demonstrates good adhesion and the edges are not curled.
b) The label resists defacement or removal as demonstrated by scraping across
the test panel with a flat steel blade, held at right angles to the test panel. The
blade is to be 0,8 mm thick and of any convenient width.
c) The printing is legible and is not defaced by rubbing with thumb or finger
pressure.
Label Heating Test
MARCH 26, 2004
CAN/CSA-C22.2 NO. 60745-1-04
♦
UL 60745-1
36
Copyright Underwriters Laboratories Inc.
Provided by IHS under license with UL
Licensee=CSA Group/5934117001, User=YUEN, Ruby
Not for Resale, 12/21/2004 21:51:39 MST
No reproduction or networking permitted without license from IHS
--````,```,`,`,``,`,,,,,,,``,,,-`-`,,`,,`,`,,`---
Three samples of the label applied to test surfaces as in the intended application shall be
placed for 240 hours in an oven maintained at the temperature specified below.
Maximum Temperature During Temperature Test of
Surface to Which Applied
Dostları ilə paylaş: |
