Automatic computer control incubator xm-18 Operation Instruction

Welcome to use our automatic incubator by computer!
Please pay attention to the following aspects in use:
1. The micro-computer controller has been made adjustment for temperature,
humidity, egg-turing, exhaust, etc. before leaving factory, which meets settings
required by incubation. Under normal circumstances, you do not need to set
up and may use it by connecting the power supply. Factory settings:
temperature 38 °C, humidity 60% RH; cycle of egg-turning: 90-minute, time
of egg-turning: 180 seconds; ventilation cycle: 120 minutes; ventilation time:
30 seconds; egg-turning state: automatic egg-turning.
2. If you need only to change the temperature and humidity parameters, please
refer to Section in in page 2 of this Manual. Please do not set up other
parameters in order to avoid operation errors which may affect your usage
and bring you f unnecessary losses.
3. Temperature and humidity sensors are made of high precise and micro-
molecular materials, please do not make the sensor come into contact with the
water directly. The dust must be regularly cleared on the surface of the sensor,
or it will affect the measurement accuracy.
4. The manufacturer should only assume the obligation for products selled to
users, but not undertake users' other losses caused by product failure.