272
Description of specifications
Drawbar load
The
maximum permitted drawbar load on the ball joint of the towing bracket
must not exceed
75 kg.
In the interest of road safety, we recommend that you always tow approach-
ing the maximum drawbar load. The response of the trailer on the road will
be poor if the drawbar load is too small.
If the maximum permissible drawbar load cannot be met (e.g. with small,
empty and light-weight single axle trailers or tandem axle trailers with a
wheelbase of less than 1 metre), a minimum of 4%
of the actual trailer
weight is legally required for the drawbar load.
WARNING_●_For_safety_reasons,_do_not_exceed_the_80_km/h_limit._This_is_also_valid_in_countries_where_higher_speeds_are_permitted._●'>WARNING
●
For safety reasons, do not exceed the 80 km/h limit. This is also valid
in countries where higher speeds are permitted.
●
Never exceed the maximum trailer weights or the drawbar load. If the
permissible axle load or the permissible total weight is exceeded, the
driving characteristics of the vehicle may change, leading to accidents,
injuries and damage to the vehicle.
Wheels
Tyre pressure, snow chains, wheel bolts
Tyre pressures
The sticker with the tyre pressure values can be found on the inside of the
tank flap. The tyre pressure values given there are for
cold tyres. Do not re-
duce the slightly raised pressures of warm tyres
⇒ .
Snow chains
Snow chains may be fitted only to the
front wheels.
Consult the chapter “wheels” of this manual.
Wheel bolts
After
the wheels have been changed, the
tightening torque of the wheel
bolts should be checked as soon as possible with a torque wrench
⇒ .
The tightening torque for steel and alloy wheels is
120 Nm.
WARNING
●
Check the tyre pressure at least once per month. Checking the tyre
pressure is very important. If the tyre pressure is too high or too low,
there is an increased danger of accidents, particularly at high speeds.
●
If the torque of the wheel bolts is too low, they could loosen while the
vehicle is in motion. Risk of accident! If the tightening torque is too high,
the wheel bolts and threads can be damaged.
Note
We recommend that you ask your Authorised Service Centre for information
about appropriate wheel, tyre and snow chain size.
273
Technical specifications
Technical specifications
Checking fluid levels
From time to time, the levels of the different fluids in the ve-
hicle must be checked. Never fill with incorrect fluids, other-
wise serious damage to the engine may be caused.
Fig. 185 Diagram for the
location of the various el-
ements
Coolant expansion tank
Windscreen washer fluid reservoir
Engine
oil filler cap
Engine oil dipstick
Brake fluid reservoir
Vehicle battery (underneath the cover)
The checking and refilling of service fluids are carried out on the compo-
nents mentioned above. These operations are described in the
⇒ page 217.
1
2
3
4
5
6
Overview
You will find further explanations, instructions and restrictions on the tech-
nical specifications as of
⇒ page 269.
Safety First
Operating Instructions
Practical Tips
Technical Specifications
274
Technical specifications
Petrol engine 1.4 63 kW (85 PS)
Engine specifications
Power output in kW (PS)
rpm
63 (85)/ 5000
Maximum torque
in Nm at rpm
132/ 3800
No. of cylinders/capacity
in cm
3
4/ 1390
Fuel
Super 95 RON
a)
/Normal 91 RON
b)
a)
Research
Octane
Number = Anti-detonation rating of the petrol.
b)
Slight power loss.
Performance
Maximum speed
in km/h
172
Acceleration from 0-80 km/h
in sec.
9.2
Acceleration from 0-100 km/h
in sec.
14.1
Weights
Gross vehicle weight
in kg
1745
Weight in running order (with driver)
in kg
1250
Gross front axle weight
in kg
900
Gross rear axle weight
in kg
895
Permitted
roof load
in kg
75
Trailer weight
Trailer without brakes
in kg
620
Trailer with brakes, gradients up to 8%
in kg
1200
Trailer with brakes, gradients up to 12%
in kg
800
Engine oil filling capacity
Approximate engine oil capacity with oil filter change
2.8 litres
